Oricom UHF400R 80 Channel 5 Watt Heavy Duty Din Size UHF CB Radio

Specially Built for Australian Transport Oricom’s UHF400 features 12v/24v auto switching which makes it quick and easy to install in any truck regardless of power supply. The external heat sink ensures you maintain a full 5 watt power output and has tuned sensitivity to ensure optimal reception. Features: 80 CHANNELS Allows you to choose from 80 transmission frequencies (75 voice) to transmit or receive messages 12v/24v Auto Switching For easy installation into any vehicle regardless of power supply Automatic Level Control (ALC) For consistent audio output levels 5 Watt Maximum TX Output Power Maximum transmit power for best possible range 200 Receive Only Channels Allows you to program in other channels in the UHF frequency between 400MHz to 512MHz and monitor transmissions Duplex (Range Extender) Capability Local repeater stations area. This extends the effective range of the radio, giving you the greater reach 38 interference eliminator codes (CTCSS) Block out any unwanted conversations Open/Group/Priority scanning Gives you the option to scan all channels in memory and lock on any active channels or to select the channels you wish to monitor/listen to in a group, along with a priority channel (priority watch) Large easy to read Colour LCD display (green/amber) The keypad and Liquid Crystal Display (LCD) is backlit for easy viewing at night or in low light situations Rugged chassis construction with integrated heat sink The external heat sink cools quickly, ensuring the radio maintains the highest possible output power UHF400R – with rear mic jack 5 Year Warranty – Peace of mind. Buy your Oricom product with confidence. Specifications: GENERAL Compliance: AS/NZS 4365:2011 Frequency Range: TX/RX 476.425 – 477.4125 MHz/ 400 – 512MHz Number of TX/RX Channels: 80 UHF CB Channels (75 voice) Channel Spacing TX/RX: 12.5KHz Operating modes: Simplex, Repeater TX offset (+750kHz) Scanning Speed: 130 msec per channel Antenna Impedance: 50 Ohms Automatic Level Control: For consistent audio output Operating Volts Range: 10 to 30 VDC Over Voltage Protection: voltage regulator Over Current Protection: 2 AMP fuse Reverse Polarity Protection: Series diode Frequency stability: +/- 2.5ppm RECEIVER Circuit Type Dual conversion: superheterodyne Intermediate Frequencies: 1st IF = 21.4MHz , 2nd IF = 450kHz Maximum usable sensitivity: < -123dBm at 12dB SINAD Audio output power: 3 Watts Maximum RX Audio de-emphasis: -6dB/octave 300Hz to 3kHz Spurious Immunity: > 70dB TRANSMITTER RF Output Power Nominal: 5 watts Modulation: F3E(FM) Maximum deviation: 2.5KHz Spurious Emissions: <-30dBm TX Audio pre-emphasis: +6dB/Octave from 300Hz to 3KHz Current consumption during TX: 1.6AMP with 50ohm antenna termination *This 80 channel narrowband radio has a total of 75 useable voice channels Channels 22 and 23 are used for Telemetry and Telecommand, voice communications are not allowed on these channels. Channels 61,62 and 63 are guard channels and are not available for use.